About SH2900DX 1, the output power of 2KW; 2, AVR metal, plastic door push rod, good carburetor; 3, with oil level indicator, with voltage meter; 4, rotary three pine socket; 5, the low-end cover generator, with hole; 6, motor diameter 160mm, length 90mm silicon steel; 7, good damping pad; 8, deep red tank, starting cover and the motor cover; 9, with engine oil alarm.
Please see the pictures of this product.
Each part of the introduction please see below
(1)Engine Switch To start and stop the engine. (2)Recoil Starter To start the engine,pull the starter grip lightly until resistance is felt,then pull briskly. (3)Fuel Valve It is located between the fuel tank and carburetor.When the valve lever is in the ON position,fuel is allowed to flow from the fuel tank to the carburetor.Be sure to return the lever to OFF after stopping the engine. (4)Choke Rod The choke is used to provide an enriched fuel mixture when starting a cold it can be opened and closed by operating the choke rod manually move the rod out toward CLOSED to enrich the mixture. (5)Circuit Breaker The circuit breaker to protect the short-circuit current in circuit, when the short circuit occurs in the circuit, immediately disconnect the circuit, the protection of the safe load. (6)Ground Terminal The generator ground terminal is connected to the frame of the generator, the metal non-current parts of the generator,and the ground terminals of each receptacle. (7)Pilot Lamp It is illuminated when the generator is operating normally. (8)DC Terminals It may only be used for charging 12 volt automotive type batteries.
How to use AC Operation 1. Start the engine. 2. Switch ON the AC circuit breaker. 3. Plug in the appliance. Most motorized appliances require more than their rated wattage for startup. DC Operation Connecting the battery cables: (1)Before connecting charging cables to a battery that is installed in a vehicle,disconnect the vehicle’s grounded battery cable. (2)Connect the positive(+)battery cable to the battery positive(+)terminal. (3)Connect the other end of positive(+) attery cable to the generator positive(+)terminal. (4)Connect the negative(-)battery cable to the battery negative(-)terminal. (5)Connect the other end of negative(-)battery cable to the generator negative(-)terminal. (6)Start the generator. Starting the engine (1)Make sure that disconnect all electrical loads from panel receptacles.The generator man be hard to start if a load is connected. (2)Turn the fuel valve to the ON position. (3)The automatic choke will be close if the engine is cold.If you want to operate the choke manually,move the choke rod out to the CLOSED position. (4)Start the engine with recoil starter: Turn the engine switch to the ON position. Pull the starter grip lightly until resistance is left,then pull briskly. (5)If you have manually closed the choke ,move it to the OPEN position as the engine warms up. Stopping the engine In a emergency: To stop the engine in an emergency,turn the engine switch to the OFF position. In normal use: (1) Disconnect all electrial loads from panel receptacles. Disconnect DC battery charging cables. (2) Turn the engine switch to the OFF position. (3) Turn the fuel valve to the OFF position. |